Docket Number:02A-1010402
Inventor:Ing-Shouh Hwang, Wei-Tse Chang
IP Status:TW I472651、 US 8,966,661 B2
Abstract:
The proposed fabrication is to overcome the limitation that the tip profile is difficult to modify. Neither a complicated mechanical set up nor an electronic cutoff circuit is required. A commercial function generator is employed to fabricate tungsten tips with a desired profile. Tips with ultra high aspect ratio can be obtained. The radius of curvature at apex can be controlled less than 10 nm. The surface roughness and cone angle can be controlled independently.
Fields of Application:
- Scanning probe microscopy
- Field emission electron or ion sources
- Conductivity measurements, such as the four-point-probe measurement
Advantages when compared to the existing technologies:
- Rapid process and simple setup Neither a complicated mechanical set up nor an electronic cutoff circuit is required. A commercial function generator is employed to fabricate tungsten tips with a desired profile.
- Radius of curvature (ROC) at apex is tunable Tungsten tips are typically fabricated with direct current (DC) etching by employing an electronic cutoff circuit. ROC at apex ranging from 30~10 nm can be obtained when cutoff time within the range of 30-5 ns. In the proposed fabrication, the ROC between 50~7 nm can be achieved by applying pulses with pulse width ranging from 100~1 ms.
- Tips with ultra high aspect ratio can be achieved (Aspect ratio, AR = tip length / wire diameter ) In conventional fabrication, the highest AR is 30. In the proposed fabrication, the AR of 100 is achieved.
- Cone angle is tunable A method used to control the cone angle effectively is still lack. In the proposed fabrication, the cone angle can be controlled independently, they vary form 3.8°~9.1°. If the dependency of cone angle on ROC is neglected, the variation of cone angle ranges from 3.2° to 17.4°.
Contact Person:
對本技術有興趣,請於本處網頁廠商選項下(廠商需求與諮詢)網頁填寫資料,承辦人將跟您聯絡。
If you are interested in this technology, please fill in the information on the webpage under the manufacturer option (Apply for Technology Licensing, Material Transfer, or Sponsored Research) on the website of this office, and the undertaker will contact you
