Updated time: 2021-02-02 17:41:46
26A-1061221
TW I681587、PCT pending
Increasing demands of electronic device with high energy density is the motivation to develop lithium-sulfur battery as next generation battery technology. Shuttling of polysulfides between the electrodes is key challenge in developing Li-S battery technology. The shuttling phenomenon lower the utilization of active material and decrease the cycle life very fast. Herein, we report a bilayer separator: one side coated with MoO3 nano-rods while other side is polypropylene separator. Commercial bulk MoO3 particle is grinded using a home-made grinding machine in IPA solution to produce MoO3 nano-rods. At 5C, Li-S battery with MoO3 coated separator shows excellent performance up to 2000 cycles with decay rate of 0.01196% per cycle. 76.08% initial discharge capacity retained after 2000 cycle at 5C while culoumbic efficiency maintained above 80% that shows free movement of Li+ ions within the electrodes. We believe our modified separator has good potenetial to be commercialize for the development of Li-S battery.
Our proposed technology enables ultra-fast charge-discharge rate in Li-S batteries and makes them possible to be commercialized as next generation batteries. Battery performance at 5 C shows that it is possible to charge Li-S battery within 5 mins that is less than the time we need to refill the gas chamber for our vehicles. Li-S battery using our proposed technology will perform very good stability even at high C-rate.
Using this technology, commercialized battery can be applied in electronic appliance, such as hybrid electric vehicle (HEV), telecommunication, portable electronics, and device for renewable energy like solar and wind.
Chih-Wei Chu, Nahid Kaisar, Sayed Ali Abbas
If you are interested in this technology, please fill in the information on the webpage under the manufacturer option (Request for Technology Licensing, Material Transfer, or Sponsored Research) on the website of this office

Fast charging & long life Li-S batteries